About this 3D model

With a Christmas theme in mind, here we have a bell designed using Fusion 360 and mainly the revolve tool. A free bell silhouette is first downloaded and then import that in as a canvas and then use the fit point spline tool to trace the edge of one side of the bell, offset that to 2mm and close the ends and trim as necessary, then use the revolve to to a mid point axis to create the solid. I sketched on top of the bell using the mid plane to firstly create a symmetric square then used the fillet to the top sides and then fillet sides and where it attaches to the bell, lastly a 6mm hole was sketched and extruded enabling the bell to hang from the tree as a single or pair. Printed with the BambuLab X1 Carbon Prints as is no support needed. Thanks for looking.