About this 3D model

Lid plate for Model WRSC-6, 9.0A 1 Phase, 115 V ~ 60Hz water pump for use in basements. My pump is very old and I've never cleaned it out. I removed the plate that holds the filter and the entire thing began to disintegrate as soon as I tried to wash it. This plate matches the dimensions of the lid almost perfectly. A little wiggle room was given with the screw diameter based on printer tolerances. You'll need to use an O-Ring around the inner piece to truely make it water tight. Tested several times with medium and hot water using PLA, although I will probably re-print with ABS to ensure high water temperatures will not deform the material.