About this 3D model

This is my OpenLOCK TerrainTiles system that allows for modular boards with height variation without sacrificing scatter placement, It also creates the unique opportunity for underground sections with standard OpenLOCK tiles fitting perfectly inside raised areas. Surfaces in this set are intended for applying flocking/textures, A set of basic flat tiles is available for free and the best place to start as they are the foundation of this system v v v * NOTES * v v v This system has some drawbacks, The first is the simple fact that OpenLOCK tiles connect sideways and that creates some inherent friction when constructing a full board but if you stronly connect sections that are then loosly connected it's not too bad. Secondly the length of the slope tiles is 3 basic tiles (due to the angle), this disrupts the grid of the board but can be locally mitigated into even sections. And third, despite not requiring much infill it does take a fair amount of filament for a full board. Yeah so it's not as quick and easy to setup as I would have liked and would not be the best fit for everyone, but it's not that bad and it is highly adaptable * naming convention uses inches * These models use the OpenLOCK system by Printable Scenery (printablescenery.com) under a free license and are not endorsed by Printable Scenery License: printablescenery.com/2025/10/28/silvergum-studio