About this 3D model

The “Clean Cut” is a wrapping paper cutter that makes cutting wrapping paper a breeze. Wrapping paper cutter for the cost of 0.99 cents of filament and a number 11 X-acto blade! With design improvements and a proven cutting technique that cuts buttery smooth. Designed specifically for current wrapping paper rolls with a diameter of 48mm (1.89"). Features And Benefits Beveled and filleted edges around the cutting blade helps the paper to flow reducing the likelihood of snagging. Rounded edges help direct the paper into the cutting blade reducing the likelihood of catching and tearing paper. Correct diameter for 48mm wrapping paper rolls aids control without having to squeeze it to size. WARNING: Care must be given when installing the blade. Using needle nose pliers is the safest and best way to install the blade. Install the blade and use this model at your own risk. NOTE: You MUST use a new and sharp number 11 X-acto blade. Using a dull blade will cause tearing, rather than cutting, of the wrapping paper. This is designed ONLY to be used as shown in the photos. Using it with the printed side of the wrapping paper up will not deliver consistent results. Printed side of the paper must be face down as shown in the photos. This will require some practice to get consistent results. Think of it like using scissors for the first time. Try it a few times on some scrap wrapping paper until you learn to use it as designed. Keep in mind, this is not designed to just plow through the paper at warp speed. I have used on dozens and dozens of cuts without issue. So, if you are having an issue, it is either the sharpness of the blade or the way you are using it. This works very well when used correctly and with a sharp blade that is correctly installed.