About this 3D model

This little guy greets me each morning and helps me get ready with a delicious cup of coffee. Creating this stand was the perfect way to add a little bit of personality to my french press. It was a relatively simple print with no supports required and does not take up much counter space. If you print please let me know on my Instagram: @mikemakes3d. This stand fits my french press really well, but I would like to hear from some people if theirs will also fit. I printed all components with 0.2mm layer height at normal PLA temperatures. No supports were needed on any of the parts. The Right Arm.stl and the Hand.stl were printed with 50% infill for extra strength, but the Base.stl was 15% standard infill. Also, be sure to print the arm and hands with the flat side down, fingers facing up (should be obvious from the geometry).