About this 3D model

The BitJoint is a bit-attachment that makes it possible to screw into even the most tricky corners. The non-rotating handle makes it easy to use. Magnets can be used inside to prevent the bit-attachment from falling out. Max angle approx. 30 degrees It holds surprisingly well, but watch the torque anyway. It's still plastic. :) Printing instructions: I have printed all parts in PETG. make sure that the Bed adhesion brim type is on "outer brim onley" with a width of 6-10 mm. I printed the center part (the part in yellow) and the BitStick with 100% filling and 4 wall thicknesses, the rest was printed with 20% infill and 4 wall thicknesses. All parts can be printed without support. Materials required: 2 x M3x20mm screws 2 x M3 nuts 2 x 6x2mm magnets Be careful when tightening the screws and nuts, or the brackets may break.. I am open to suggestions for improvement and remixes. enjoy