About this 3D model

Model Remix (Please read it all) Bin dimensions: 220x220x350mm (or 220x220x450mm with the extension) so it fits quite a LOT of mess before needing to be emptied. --- The “ Can” can be used by itself. --- The “ Top” needs supports only in the holes and down of them. --- I think the “ Lid” prints better on his side, and with a modifier to fill the back part with more infill, so it can go back to his place. Needs supports and maybe will need a bit of work to remove them and sanding but the ugly part will be on his side so you can't see it when mounted… --- You need two “ Pins” , remove the brim and simply push it through the lid hole deep into the hole of the top piece, and you are good to go. --- The “ Extension” gives 100mm extra high, it comes in a separate model because the print volume of the printer, it keeps in place by an insert in the “can” but i glued it to be permanent. I highly recommend to print the body base and the extension from my tested 3mf, i cannot assure you the right fit if you slice with another settings. --- I uploaded the .3mf/print-profile files with the settings. All the parts are on the same profile, just choose to print the plate you need.