About this 3D model

UPDATED FILE ADDED. I have added an updated file that includes HIGH SIDES in case you are having issues with poop bouncing over the edge (I myself have not had any issues – but some have reported this) PLUS I’ve added a slightly thicker section where the chute mounts to the screw on the back of the machine. Again, I’ve had no issues with mine but some people say it’s not strong enough?? So the updated file could help. The updated file also comes in BRIM and NO BRIM versions. IMPORTANT. Some users have noted that the HIGH SIDE version rubs against a rear mounted spool. I've added an additional version with a small cut-out to allow for the rear spool. There are numerous variations out there for this product. I wanted to print a simple but effective dump box and I thought instead of using magnets to hold it in place just use the existing screw that holds the chute in place. NOTE: I unscrewed the original black screw from the lower mount of the dump chute. Then used one of the slightly longer silver headed screws - I think it was used in the packaging material from delivery. Leave it unscrewed a little for the chute to clip onto. This design appears to be very thin in body thickness but I didn't see the point in printing one with 3mm or 4mm thick walls. It only holds lightweight filament. This is easy to remove for emptying and does not effect rolls mounted on the rear of the printer. I'm sure other designs serve their intended purpose. This is a very straightforward design and I thought it might be useful to someone. It might appear to be a remix of someone else's work and with the amount of these chutes out there it's quite possible. Apologies if this is the case. Boost Me If you feel this file helps you please shoot me a BOOST. All Boosts are greatly appreciated. This is an excellent to show your appreciation of a print profile. I personally Boost as much as I can to help the designer, hopefully you can do the same. Happy printing!!