About this 3D model

Here you have the best model until now published into the MyRCCar ecosystem ;) This is a great work from my cousin Rockser3D. He has model completely this nice 1/10 RC car body, always with FDM 3D printing in mind. If you want to see it in 3D take a look to the 3D scan with the KIDS chassis MAIN FEATURES:- The model is divided in 3 main parts, some other smaller parts as front bumper or rear trunk and a lot of extra detail parts as lights, mirrors, windows, handlers, fuel cup, radiator and some more.- It has 8 holes for lights in the front and another 8 in the rear so you can make a good "Light Show" with this one ;)- Printed in PLA it can survive some rollings (it did) but probably it won't be undestructible for some other kind of hits.- You will need something between 500g and 1000g of plastic to build the body. It has no flexible parts (recommended rearviews in TPU) but you could need transparent PLA to make the windows and light lenses.- The big parts are screwed between them instead of glued, which makes the assembled body to feel quite rigid!- You will need very little or no supports for the 3 main big parts and just some smaller supports for some of the detail parts SPECS:- Total width (without rearviews): 200mm- Total length: 490mm- Wheelbase: 280mm- Height: ~120mm Under the hood there is actually a MyRCCar KIDS On-Road Chassis and I'm using some flexible holders for the body, which make the pack quite resistant to smaller impacts and manipulation. If you have a 280mm wheelbase chassis with an axle width smaller than 195mm (maybe even little less) you will probably be able to use this body too! You will need to do the holes in the right place for your body holders or glue your magnets. You will also need a "low profile" chassis front part to be able to accommodate the body as low as possible. I have supplied you with two versions for the windows. In the 1piece version, frame and glass will be just one part. In the other hand, you can find "frames" and "Glass" for each window if you preffer to print them separately. If you are going to use it with MyRCCar KIDS On-Road, you will need some "Spacers" for the rear body holding system. Those ones are also provided.