About this 3D model

Spare rear suspension mount for the Tamiya DT-03 when no genuine spare part is available. It's pretty similar to the genuine part and - depending on your filament choice - should work just as well or even better. Notes:I used PETG for my print but other filaments should work just fine, too. For a more rigid part use a low (0.3) resolution. Infill is your choice. I used 80% and 6 perimeters (0.4 nozzle). The "DT03-rear_shocktower_etp.stl" has closed countersunk holes for better bridging results. So you don't need supports. Just use a drill or sharp knife to clear the holes after printing.