About this 3D model

Designed another version of my mask straps with a larger, near-circular center portion. The purpose is to allow the designer to quickly apply logos to these straps for whatever they intend to highlight. Simply raise the logo 1.0mm and make sure the base is flat. I find most logos can be printed when using a 0.6mm nozzle, and it takes about 20-23 minutes. I use draft setting, but make sure the logo is at least as tall as this setting (in Cura, 0.32mm). I usually just make the logo 1.0mm tall. Thicc.**If you have a specific request and don't have the design capacity, send me a message!!*****Please tip if you are commercializing! Covid took mah jerb***