About this 3D model

This is a stand designed to hold the MYNT3D Pro Pen. I believe it will work with the Super as well but this is not tested. I do not know if it will work with the Basic. No Supports necessary if overhangs are set to 48 degrees or more. I recommend printing in a color other than black, and ideally with PETG or something with a higher glass transition temperature than PLA, but PLA will work in a pinch. In my initial design I did not have a vent, and I noticed that if the pen was kept on in the cradle it heated up the chamber. I added a vent, and printed in translucent red PETG, and it seems to handle the heat fine even if I keep turning it on to stress test it. With the vent, PLA is probably okay, but I'd stay away from black because it absorbs heat. Check out my website, www.CinemaTechnica.com