About this 3D model

Introducing the ultimate Apple Watch charger base or stand! Easy to print without any support. It uses you standard Apple Watch and Apple Watch Ultra charging cable with MagSafe ( USB-C only ). This design makes it easy to attach the cable, but also easy to remove. Just press the hole in the back and the MagSafe charger pops out. Super convenient when traveling, as you don't need to carry around the charging base. NOTE There are four versions available: Total v2; Prints in 1 piece and this works for most printers and filaments. The MagSafe charger fits just snug in the base. Total v3; Prints in 1 piece and this works for printers and filaments where the MagSafe charger is a little loose. Added some nudges. 3 parts v2; Needs to be glued and this works for most printers and filaments. The MagSafe charger fits just snug in the base. 3 parts v3; Needs to be glued and this works for printers and filaments where the MagSafe charger is a little loose. Added some nudges. I would start with v2 and if that's a little loose, try v3. Prints totally fine in 1 piece without support on my X1C. It prints a little bit nicer in the 3 parts, but you could see more glue lines. I had the best result on a Cool Plate with Bambu PLA. Happy printing!