About this 3D model

Model is inspired by Nakozen's F16 fighting falcon and Viper 2 concept by Encho Enchev's . It's a mix of F16, F22 and F35 figher jets, which gives it futuristic look. My original model dimensions are quite big, so I recommend scaling it down to 15-30%. Print in place, no supports needed. It's a perfect snap fit the first time I printed, but results may vary! To tweak the tightness, simply increase or decrease the Z height in your slicer or use glue if already printed. I uploaded two versions of each part. Part 1 F16-Part1-STL is the body with pattern “engraving” F16-Part1v2-STL is the body without the pattern Part 2 F16-Part2-STL is without hanging loop F16-Part2v2-STL is with hanging loop Printing settings No rafts No supports Layer height: 0.2 mm Infill: Up to you. I printed with default 15% Material usage When scaled down to 20%, using PLA with 15% infill it uses roughly 6,4 meters of filament (~20 g) . When scaled down to 20%, using PLA with 50% infill it uses roughly 8.4 meters of filament (~26 g) . When scaled down to 20%, using PLA with 100% infill it uses roughly 11 meters of filament (~35 g) . Printing time Approximately 40 minutes when scaled down to 20% using 15% infill. Approximately 53 minutes when scaled down to 20% using 100% infill.