About this 3D model

Overview My wife saw this online, so this is not my creation other than the ready-to-go print profile, but I noticed this was on thing verse, so am just growing the MakerWorld community. I did change the clip to the wider remixed version I found on thing verse, and the print profile I made was a second try as the hook needed a bit of support for the overhang, but the second time it came out flawless. The design could probably be made better if the clip was not so loose in the slot it locks into and also a lower shelf for the lid to slide into so that it has walls above and below it might keep it from falling in. Overall, when you use it though it does successfully do its job and works nicely. Just keep in mind accessing whatever is behind the hanging tea now as you will find yourself reaching under or sliding this off and back on which isn't a big deal. For pictures please see the attached links for the original design and designer. Tip for the Print Bed was set to 45 deg C (max recommended for the cool plate and PLA combination) for 1st layer and 40 deg C for the rest. Used a 5mm brim around the edges. Had easy to remove support under the locking mechanism of the clip to assist the overhang (failed without it, but perfect with it). Enjoy and let me know if you make improvements or do anything cool with it! Love to learn!