About this 3D model

IF YOU LIKE THIS MODEL, PLEASE CONSIDER DONATING TO MY SURGERY FUND Low-poly looking cat ears with a base that allows it to be slid over the back of the headband of a pair of V-Moda headphones. Pictured here on my recently restored old pair of V-Moda Crossfade LPs (with a fresh coat of Flex Seal to fix some rotted vinyl).This will likely work on some other headphones too, but I made it for my V-Ms so that's all I measured it for! These are made to be 'removable' in that you slide them off and on and it uses tension to stay in place, but I advise sanding the hard edges to reduce it digging too hard into the headband. It's okay for there to be a slight gap between the headband and the bottom of the base as I wanted to keep allowance for headband deformations when worn, stored, resized, etc... Another thing I found handy was gluing a bit of foam between the two if you find the corners of the 'clips' dig into your head any/too much.