About this 3D model

A simple little addition to add to the top of your A1/A1 Mini toolhead to allow easier removal of the Bowden tubes on hotend side if you have an AMS. These little suckers are difficult to get pressed with fingers so this tool allows you to press towards what corner you want then wiggle the tube to come out. The holes are large enough to not interfere with the Bowden tubes and toolhead movements. Check my other prints to find the A1 Bowden tube supports and the release tool for the AMS side of the A1/A1 Mini. How to use: Place your thumb under the toolhead (Make sure not hot), then use your other 2 fingers to press straight down on the releaser. Then simply use your other hand to wiggle the tube out. A1 Bowden Tube Supports: https://makerworld.com/en/models/78732#profileId-83046 A1 Bowden Tube Release Tool AMS Side: https://makerworld.com/en/models/78741#profileId-83050