About this 3D model

Boost Me If you like my designs, please Boost Me! With boosts, I can upgrade my printing setup and make even cooler designs! An easier to print indoor boomerang that prints and flies better can be found here (only 2g filament and 5 minutes printing time with no AMS needed.[not counting preparation time])- https://makerworld.com/en/models/1576392-indoor-boomerang-v2 My goal was to create a boomerang that can be used in smaller rooms. I ended up with this design in Tinkercad. This model was created for right-handed people, but it can be mirrored in your slicer if you are left-handed. To throw, hold it nearly vertically and throw. You don't have to throw hard - just try to make the boomerang spin in the air. The boomerang flies a few feet and comes back to you. I tried to design it so that it can be used in even the smallest rooms (but probably not your closet). It is very light, so it most likely won't cause any damage to objects it hits (but no guarantees). The idea for this model was loosely inspired by other models, but this is my own design created from scratch in Tinkercad. Printing: This model is very thin. Your print bed must be perfectly leveled. If your bed is too high, there may be large holes in the print. If it is too low, the model will fall apart. If you level your printer and still have problems, I attached a thicker print profile that may print better. If you still have problems, feel free to post a picture of your print and I'll try to help. Post Printing: Let the print bed cool completely before removing. After printing, bend the edge of each wing download along the line and its TIME TO FLY!