About this 3D model

This is a large, sturdy and useful 2-piece scoop that has a narrower spout and a decent handle that is useful for filling up big birdfeeders with less spilling of seed than a typical grain scoop that tends to spill out to the sides. It prints in two parts which nicely dovetail together when finished so you can have fun with different colors. I have not had to glue the handle even after several weeks of use. The scoop body itself is big... it pretty much fills the bed of an Ender type printer and uses about 150g of filament. It tapers out as it prints. Should take around 12 hours to print at modest settings for the main scoop body and 1-1/2 hours for the handle, depending on your setup.