About this 3D model

Summary 5 to 15 % Infill 0.15 to 0.2 mm Layer Height Negative horizontal expansion is recommended: -0,02 mm to -0,06 mm The file is set 350 mm long for better results, but if you have less volume printer, scale the mesh. Use glue to glue nails' heads. *If you have trouble engaging the nails, use hot air to soften them a little. IMPORTANT NOTE: Be Careful. The Nails can harm, use smoothed nails to prevent this. Even so, this toy should not be used to harm anyone, it can do a lot of harm. Use under adult supervision. https://www.youtube.com/shorts/n1D7NG6wl_k