About this 3D model

Summary Modified the original because I could not get it to print properly - there were empty holes below the roads which caused very poor print quality. I redid the model unifying into one solid piece to remove the internal voids. I also added text on the back to make it clear to new guests that it was a replacement for the longest road trophy card. Print Settings Printer Brand: SeeMeCNC Printer: Artemis 300 ARP Rafts: No Supports: No Resolution: .12 Infill: 25 percent Filament: Zytech petg white Notes: If you want the small details like the bricks in the road to come up, make sure you have a nozzle size no larger than .4mm. I found my .5mm nozzle reduced the text and roads to a bit of a mess, irrespective of the layer height.