About this 3D model

If you like my work, i'm open for donations via Paypal. It is much appreciated. https://www.paypal.com/donate/?hosted_button_id=3KZUPFUG4KLUL Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA Bambu PLA Blue Transmission Distance: 5 PLA Bambu PLA Red Transmission Distance: 5 PLA BambuLab Matte White Transmission Distance: 4 Swap Instructions: Start with Black At layer #4 (0.4mm) swap to Blue At layer #8 (0.72mm) swap to Red At layer #15 (1.28mm) swap to White for the rest. Reminder: My models mostly cover the entire bed, this means the purge line is sometimes running through the bottom of the print. You have 3 options here: - Leave as is, you can just cut them of afterwards. - Remove immediately after the purge line is printed. - Scale the model: *** WARNING *** WHEN SCALING THE MODEL, BE SURE TO NOT SCALE THE Z-HEIGHT! The Z-height must always be as original, otherwise the print is messed up.