About this 3D model

This a simple tool to unclog your nozzle, it should work on most 3D printer. Made to use with 1.60mm rods, I used this one on aliexpress 1.60mm x 300mm , 100mm of the rod is embedded into the handle and is not usable. No tool, glue or heatgun is required, simply screw it. It's a little tight to keep the rod in place, a drop of grease can help if needed. The print profile use 2 colors and fuzzy skin on a section of the handle. A end cap is provided to protect the end. To create a 60° angle you can use this jig : https://makerworld.com/en/models/85020