About this 3D model

Summary Cable holder for IKEA BEKANT table where only the cable holder is visible from above and no glue or penetrating screws are involved. Not perfect, but works. Print Settings Printer: Bambulabs A1 mini Rafts: No Supports: Yes Resolution: 0.2 Infill: 15% Filament: eSun PLA+, white Post-Printing Instructions 1. Connect the two pieces (I used a pipe wrench and sth. to protect the surface) 2. Loosen IKEA BEKANT side screw 1-3mm 3. Slide the cable holder over the screw 4. Fasten the screw again