About this 3D model

A remix of Capt Obvious' SKR mini enclosure ( https://www.thingiverse.com/thing:4012555 ). Fits the SKR 1.4 board. Designed mostly for Core XY machines, where the control box sits up high near the extruder cabling. Includes multiple cable ports on three sides. 5 ziptie cable holders in the top cable port (near the stepper motor ports). Very well ventilated. Simple print. Just use some support from the build surface for the nut/bolt pockets. Needs 4 m3 square nuts (thin). Things to do. M4 bolt holes are a little big. Still works fine but washers aren't a bad idea. Update: Added a 'fan backpack'. This is a small adaptor that bolts to a 40mm fan (use m3 heatset inserts), and then clips onto the hex-pattern of the lid or case. Update Jun 2021: Added a mosfet enclosure for the MKS-bed Mosfet - https://www.biqu.equipment/products/3d-printer-parts-heating-controller-mks-mosfet-for-heat-bed-extruder-mos-module-exceed-30a-support-big-current