About this 3D model

Some people in the office don't remember to insert the poop bucket back in position after dumping it so I've taken upon myself to create a version making it more obvious when its not returned. I've also removed a bit of material to make it a less consuming print for my needs. I've also added a optional riser for people using Anti-Vibration feet, see updates below! UPDATED 1/18/2025 So I've finally addressed a couple issues with this chute I been meaning to. Now when the bucket is inserted the back side is flush with the chute instead of having a little lip offset. I've also made the chute more vertically for better slide action. These help stop fliament from getting stuck. I've also increased chute stability by using two 12x2 magnets and one optional 8x3 at the top. I've left the original version up though for anyone who still uses it. Profile 1: Updated Version - use this one going forward to take advantage up the improvements. Shoot slant increased, bucket will be sit flash with chute at the back, added a little riser to the top of the chute to keep poop from jumping the edge. Bucket was also updated to accommodate chute improvements. Two 12x2 magnets and optional 8x3 magnet. Chute Riser still works the same. Profile 2: Original Version - for anyone who still likes the way it was. Uses 3x9 Magnets Profile 3: Riser - for anyone using Anti-Vibration feet or raise the printer height. After increasing the height of my printer with anti-vibration feet I decided to make a riser so this chute could still be used without modification. Simply print and drop the chute in to it. It'll put the chute back up in to the proper positioning. Should even be able to increase the Z scale to fit your height needs! *Ignore the fact the center of the “B” and “R” are loose pieces in the photo. In my haste to print I forgot to realize those wouldnt be connected but have already remedied it in the profile.