About this 3D model

Construction barrel with flashing LED lighting Easy print, low poly construction (traffic) barrel. 9 pieces total, printed in orange and black filament. Flashing LEDs come prewired from EvanDesigns.com You will need two of the megas glued back to back. In order to keep both sides in sync you will need to cut the shrink tube and solder the two LEDs together (you can eliminate one of the flasher / resistors). Run the wires from the LEDs down through the light box and barrel lid. Re-solder to the flasher unit. Run a USB power cord through the barrel and connect to the flasher unit. Tip: Glue the barrel lid on last so you can access the wiring for soldering. Finish up by applying reflective tape to the second of fourth barrel rings. I will post more detailed light instructions if there is enough interest.