About this 3D model

Not sure how to market these over other spell slot trackers, so, idk, try looking at the pictures. Not sure if this is obvious or not, but you flip a token over to use the spell slot. Tokens for spell levels 1-9 are available as well as a screw-top container that is big enough to hold a full caster set of 22 tokens. Printing: Almost any settings should work. No support, no adhesion. They will probably print fine with as low as 10% infill or possibly less, but I've never tried with less than 20%. Print tube and cap the same way. Takes 7 Hrs, 45 Min, and 35 Grams of material. Finishing the Tokens: 1: Color in the details. You can use sharpie, but paint looks much better, a paint marker works perfect. I reccommend using something fine-tipped for the lines, as that makes it easier to remove the excess, I especially had issues with the level 9 token, as you can see. 2: Sand the face with 150 grit sandpaper until excess sharpie/paint is no longer visible. 3: [Optional] Sand the face with 300 grit to give a smooth finish. Picture is Hatchbox white PLA, with Sharpie brand black paint marker, using the optional 300 grit sanding step.