About this 3D model

Ever wondered what a Darth Vader force ghost would look like over Christmas? Well wonder no longer! Here's a fun HueForge print of your favourite Father Christmas (get it?) that prints relatively quick, only taking about 2 hours for the entire print. It measures 150mm x 150mm and fits in TheCraftyMaker's HueForge frame as well! Just print the 150mm x 150mm version :) P rint Instructions : Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm Note: I used Glow in the Dark filament for this one to add a little fun to the print. If you do not want the print to be GitD, replace the GiTD with just plain white :) Filaments Used: PLA Kingroon Black Transmission Distance: 0.4 PLA Glow in the Dark Green Transmission Distance: 5.2 (or White!) PLA CC3D Blue Gray Transmission Distance: 3 PLA META Sunlu Teal Transmission Distance: 5.4 -PLA Kingroon White Transmission Distance: 8 Swap Instructions: Start with Black At 0.76mm swap to Glow in the Dark Green (or white) At 0.8mm swap to Blue Gray At 0.96mm swap to Teal At 1.16mm swap to White (Do not swap after this if you do not want the glow!) At 1.60mm swap to Glow in the Dark Green (or white) ______________________________________________ If you'd like to support me, I now have a Patreon ! Joining will give you behind the scenes information on WIPs, access to a private discord, early access AND exclusive models! If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon! ______________________________________________