About this 3D model

Medium-sized lightweight bookend inspired by xyzaxis's Lightweight Bookend (Thingiverse). Simple, low-filament usage. The lower end of the vertical portion is not attached to the bottom, which removes a strain point where it would otherwise fail under heavier load. Prints with a small brim at the skinny end to decrease the chance of peeling off the bed; clip it off after printing. Suggest using a high-adhesion bed like PEI. Print Settings Line width: 0.4mm Layer height: 0.28mm 1-2 walls 20% infill Scale depth (z-axis in print orientation) to achieve desired thickness