About this 3D model

The .3mf file contains all of the parts, they should be printed as follows: Slider and knob - add brim, 0.2mm layer height Platter - 0.20mm layer height Base - 0.20mm layer height Tonearm components w/o screws (pin, tonearm holder, volume slider) - 0.2mm layer height, brim. Tonearm components w/ threads (tonearm, tonearm connector) = 0.12mm layer height, brim, regular supports everywhere. Make sure that the supports do not interfere with the threads. The tonearm connector may require some cleanup in order to function properly. I would highly recommend that you use a glue stick to secure these parts to the build plate. Infill - 10% - 20% of your preferred infill pattern should be fine. Tolerances throughout the model are between 0.2mm and 0.5mm . Adjust your printer accordingly. This should be fine for the majority of modern 3D printers. Print times should be fairly low as the majority of the parts are quite small (>10 hours total print time) 3rd picture has the part labels. This model features a rotating platter, tonearm which moves horizontally and vertically, a knob which rotates, as well as a volume slider which slides up and down. Loosely based off of the Technics SL-1200.