About this 3D model

7 or 14 day pill organizer with 14 compartments. Prints in one piece without supports and folds to close. 165g filament used for the hexagon version and 170g filament used for the non-hexagon version. Should print fine in PLA but might last longer if printed in a more flexible material like PETG. There is also a 2 compartment version availible that was used for testing the hinge. This version uses 36g of filament 0.2mm layer height recommended, 0.28mm may work as well if the ~5 bottom layers are 0.2mm. 40% Lightning infill was used to reduce the amount of filament but there isn't too much infill so any infill should be fine.