About this 3D model

Print Parameters 50%+ Favorite Infill (no lightning infill) 5 walls 0.28mm layer height Material Use and Print Time 32g PLA+ filament used 2h 25m print time (5 walls, 50% cubic subdivision on Ender 3 Pro at 50mm/s) I printed in Inland PLA+ and had good strength but PETG would probably be the best material for this. Wall Mounting Hole is 6mm in diameter Base in 5mm in thickness so account for that in screw selection Use Cases Small hooks should be plenty strong for even the biggest wad of keys Big hooks should be fine for a small bag or purses (especially in PLA+ or PETG)