About this 3D model

A flying toy to surprise your friends when it flies out of a letter, book, card, magazine, etc. There are so many kinds of these butterfly toys, and you can get it easily from the Internet. It was designed to fit the 30mm long rubber band. So, this is much smaller(65mm wide x 60mm tall) and lighter(about 850mg) than other fliers. Print Settings: Printer: Anycubic Mega S Rafts: No Supports: No Resolution: 0.2mm layer thickness Infill: 100% You can make a small bushing (from an aluminum can) beetween the hook and the front part to make it turn better.