About this 3D model

This is a modular pin board that connecs with little hands. the hexagons fit on the Prusa Mk3s Printer. Use "Schablone" to cut the cork hexagons which can be hot glued into the printed hexagons. For the hands there are different versions with 0mm, 0.01mm, 0.02mm, 0.05mm and 0.1mm clearance. try what works best fo you. They should fit tight togeher to not loosen too easily. To mount it on the wall there are pockets on the back of the hexagons, only 2 or 3 screws/nails are needed for the whole assembly.