About this 3D model

Box or Mount for GPS GNSS Powerhobby or SkyRC GSM020 models with charging port. Designed to be installed inside an RC vehicle, with a opening to observe the status LEDs and a opening to load the GPS without having to remove it. It can be printed on PLA or PETG. If the printer is properly calibrated, no adjustment is required, the GPS enters without difficulty and is perfectly adjusted. The 4 screws that are required to put the cover are of the M2 x 5mm type. Print Data ( PLA ) :Layer: 0.2Shell: 0.85Infill: 30% - 50% (More resistance in case of impact)Support: Yes. (I recommend it so that the loading port is not deformed.)