About this 3D model

Place for your nozzles in a familiar shape! Just two easy-to-print parts. There is place for 36 nozzles in total - 6 of each size (0.25, 0.4, 0.5, 0.6, 0.8 and 1.0). You can also put one of your nozzles to the “hotend” :) Printing instructions Part 1 Use 0.2 layer height or less with 20% infill It does NOT need any supports GO VERY SLOW ON THE FIRST LAYER. Part 2 0.2-0.24 layer height with 20% infill You need to use supports only for the “legs” that will go into part 1 Assembly instructions Just insert part 2 into part 1. I made the tolerance very forgiving so everyone can print it with any device, because of this you might need to use superglue to hold it in place properly and permanently The "hotend nozzle" can be screwed in or again - superglue If you need anything, feel free to send me a message and I will try to help you out! My Twitter :)