About this 3D model

DIY holder for old stock intel CPU cooler with 7,5x7,5 cm mounts. instructions: 1) put wire thrught holder 2) put thermal paste on the cooler/LED chip 3) place holder in the center of cooler 4) twist holder way that it locks under the stock mounts of the cooler 5) MAKE SURE LIVE WIRES ARE NOT TOUCHING THE HEATSINK!!! I strongly recommend using thermal paste and fan, becouse it gets really toasty after a while (especially the more powerful ones). better to print from temperature resistant materials. If you want to remix here is link to the fusion360: https://a360.co/2CrPdJx Print Settings Printer: ender 3 Rafts: No Supports: Yes Resolution: 0,4 Infill: 100 Filament: miroluk pla black Notes: DIY holder for old stock intel CPU cooler with 7,5x7,5 cm mounts. instructions: 1) put wire thrught holder 2) put thermal paste on the cooler/LED chip 3) place holder in the center of cooler 4) twist holder way that it locks under the stock mounts of the cooler 5) MAKE SURE LIVE WIRES ARE NOT TOUCHING THE HEATSINK!!! I strongly recommend using thermal paste and fan, becouse it gets really toasty after a while (especially the more powerful ones). better to print from temperature resistant materials. Category: Electronics