About this 3D model

here is a flush cap for the metric ac raw water strainers commonly used by nordahvn and probably most of the asian boat builders. this one fits the smaller strainer with more coarse thread. this cap uses a size 225,226 or 227 o-ring. the cap screws on and the outlet on top is non tapered 3/4" female garden hose thread. there is a spot modeled in to insert a rubber garden hose gasket/washer then you can use a quick disconnect like shown in the picture or i included a 3/4 GH x 5/8 id hose adapter as well, if you are going to cycle something like a descaling fluid with a pump. the one pictured was printed in ppa-cf with pc support but petg or pctg may be a good choice as well using pla support