About this 3D model

Paper roll holder for horizontal surfaces. Their are also 2 screw holes for mounting to horizontal or vertical surfaces. Use both screw holes. If only the top/under the roll screw hole is used, when pulling off the note, the torque will cause unwanted results. Prints without support. Assembly is flexing the knife in place, screwing in a roll of paper, unrolling the paper under the knife, then sliding the paper guide over the paper. Pencil/pen hook to keep a writing utensil ready and close for note taking. Uses 3inch wide by 128 foot paper rolls. Shorted rolls of paper will also work.