About this 3D model

The STL of this model is not ready to print. You have to add modifier to create mesh for moisture at the back of the nest like in the picture. I also uploaded Prusaslicer project file(.3mf). This should be much easier, you just open it with Prusaslicer then choose your print setting, printer and filament profile then print. After you printed, you will need a 2 cm. wide X at least 12 cm long clear X 2 mm. thick acrylic sheet as an inner lid, a piece of PVA sponge is optional, I add it as ants can drink water from it. The nest can connect to an acrylic Outworld made for 15 mm. tube.