About this 3D model

I have designed the card slot to be slanted so that users can better retrieve it, and you only need to tilt the box slightly to clearly see the name of the card. I designed the card slot to be slanted so that users can retrieve it more easily, and you only need to tilt the box slightly to clearly see the name of the card. To prevent the edges of the model from scratching my fingers, I chamfered all the edges, but the cost was that the printing time increased, hahaha. To prevent the edges of the model from scratching my fingers, I chamfered all the edges. However, this increased the printing time, haha. I used a different low-speed material for the “ With lid ” version, so the profile shows a longer print time. The actual print time depends on the materials you use and the print parameter settings. The lidded version was printed with a different, slower material, which is why the profile shows a longer print time. The actual print time will depend on the materials you use and the print parameter settings. I hope this can help you! I hope this helps! No lid： Print parameters: Print with： 0.2mm layer height 0.2mm layer 3 walls, 2 walls are also acceptable 2 or 3 walls 15% infill 15% infill No support, No brim No Support, No Brim With lid： Print parameters: Print with： 0.2mm layer height 0.2mm layer 3 walls, 2 walls are also acceptable 2 or 3 walls 15% infill 15% infill With support Normal Support（Auto） Support Angle Threshold Angle 30° No brim No Brim The card slot is in the original model file Blank card slot In “ Raw Model File ” You can add your own text You can add your own text 1mm font height 1mm font height Enjoy!