About this 3D model

This is designed for a Datsun 280zx replacement center console part that goes around the boot of the cart shifter. It is not a direct replacement as the original that I had was far too deteriorated to be modeled on. Because of this, the design will match the part cutout as best as possible while providing a little coin holder similar to the original part. You may also need to do some sanding or similarly fine adjustments to the finished print as going from memory it was a little tight. For people who cannot fit the entire print on their printer. I have added Side A and Side B to STL files to this model. You will need to glue the two parts together. Printing Recommendation : If you would like better print quality than what I have in the pictures. I would recommend you use variable layer height in your slicer settings. This will help remove the layer lines you see in my example pictures. NOTE : Make sure to print from a higher temp filament as cars tend to get very hot and will cause lower temp filaments to melt.