About this 3D model

Simone Giertz invented a foldable coat-hanger and ran a kickstarter campaign . I designed a 3D printed version. Print Settings Material: PLA Layer height: 0.2 mm Perimeters: 3 Top layers: 3 layers (concentric top layer pattern for hangers ideally) Bottom layers: 3 layers Infill: 30% (ideally cubic or gyroid) Supports: yes (just for holes and round underside of the coat-hanger) Print Instructions Print is easy, use supports for screw holes (use 1mm support/object xy distance for holes) and for bottom side of the round part only (use standard supports, not organic/tree). There is a 3mf for BambuStudio/OrcaSlicer with everything set up. Assembly You'll need: M3 bolt (ideally 10mm long) M3 nut Steps: Remove supports. Insert M3 nut into bottom part of the connector. Put coat-hanger into the bottom part. Put the top part of the connector on top. Screw in M3 bolt. Enjoy!