About this 3D model

The FilSwa Project is yet another Display Board for the Bambu Filament Swatches. I´ve printed some versions out there of this Display Boards and all of them has one big issue for me, you have to push out the Swatches from the back. Then i designed some prototypes. For the first you needed long Fingernails or a little Tool :-) to push them out. In the Second Version i designed a push mechanism from the Front, that was the best option for me. The Third Version Combines both Options + the Stock Option from the back. In this stadium you can test the Third Version. It´s a 4.6gr little Display for 2 Swatches only for test purposes! ( Print time about 16min ) UPDATE 20231224 Added 3mf for 8x8 - Now you can also print an 8x8 Version Just push on the lower side of a swatch to push them out or use your long Fingernails :-) on the top or last but not least use the push from the back! If you like give me Feedback for changes. I think a Release of a first 8x8 Board for up to 64 Swatches is near. Project Update 20231224 - Merry Christmas ? First print of an 8x8 Display Board well done. Little improvements WiP