About this 3D model

Another wall light - this one was requested by a family friend for use in his home bar. This is based on a early 90's logo they used. As a way of introduction Harp Lager is a beer originating in Ireland, not sure how well or far it has travelled, if its actually know of out side of Ireland and its not really something I would drink but I can remember as a child my dad drinking it and thought it may be of interest to someone else. I haven't printed this yet as I am waiting on the Blue filament arriving - and the model is currently set the the light should only shine through the Harp and the writing, once I get printed I will share a few pictures My settings for printing are the 0.2mm standard on Bambu slicer with a couple of tweaks: Fuzzyskin - Contour 0.4mm distance and 0.1mm thickness No Brim Wall Generator - Arachne increase the flow ratio slightly - go from 0.98 up to 1.05 Use a Textured PEI Plate and you should be all good For lighting on all of my light boxes I am using a USB powered LED light from Amazon with a bluetooth controller allowing me to control from my phone