About this 3D model

9mm ammo case with sliding lid. Holds 50 rounds. Fits most 9mm variants up to 9mm Winchester Magnum, which is @ 29.5mm in length. So any 9mm variant that's 29.5mm and less in length should fit. If the tray doesn't fit snug: Place a drop of superglue on each post and then press the tray onto the posts. Let the glue fully dry and before placing ammo inside, or before sliding the lid on. This is to prevent any superglue residue or “bloom” from getting on your ammo and lid. When printing the tray that you stick the rounds into you may have to adjust the X-Y hole compensation , depending on how well your printer is calibrated. I printed on 2 separate Bambu Lab machines without having to adjust it and both fit the ammo perfectly, but I figured I'd post this info just in case. If lid it too loose/tight when sliding you can scale the Y-Axis up/down by 0.2. If you do this make sure that Uniform Scale is NOT checked and only the lid is selected Printed at a 0.20 layer height. 12-25-2023 Added profile for tray that is easier to put in. Added profile for a grooved lid for easier grip when sliding it on/off.