About this 3D model

This Bottle-Holder is for 0,5L NRW Beer-Bottles (check the pictures) with a diameter of ~70mm and a height of ~260mm. It's the type of bottle that's mainly used in Austria, Germany and Swiss. It should stop them from rolling around inside your fridges. I also strongly recommend the suction pads, as they stop the Bottle-Holder from sliding around. :) I made the files from scratch with Fusion360 but I have been inspired by Arne S. (https://www.printables.com/de/model/210593-beer-bottle-holder-for-the-fridge-different-bottle) ---------------------------------------------------------------------------------------------------------------- If you want to help me out a bit and see some stuff I made, work in progress, or models before they will be here consider liking and following my Facebook page , thank you very much - it means a lot to me! :) ---------------------------------------------------------------------------------------------------------------- Print with: PLA 3 wall loops and top/bottom shell layers 5% infill no supports are needed for any part no brim needed for any part use slow speed - else the nozzle may push against the beams Parts: NRW_Bottle_Holder_Modular_3X A row of three spaces for your bottles ~150g filament 213x73x151mm NRW_Bottle_Holder_Modular_1X A space for your bottle ~50g filament 73x73x151mm NRW_Bottle_Holder_Modular_Bolts 4 printable bolts, for one side. ~5g filament per set 5x5x10mm NRW_Bottle_Holder_Modular_Suction 4 printable bolts, to attach suction pads. ~5g filament Made for usage with the 20mm ones found here: Suction Pads @Amazon EU This is my Amazon ref-link, won't make a difference for you, but helps me :) Six Pack: 2 times NRW_Bottle_Holder_Modular_3X 3 times NRW_Bottle_Holder_Modular_Bolts Some glue may be needed ~300g filament optional suction pad adapters are available Updates: none so far ---------------------------------------------------------------------------------------------------------------- I'm looking forward to your comments and makes. :)