About this 3D model

This holder consists of two parts. The lower one has to be printed once, then you can stack any amount of upper parts on it. It is able to hold eggs ranging from S all the way up to XL. Each part can hold 10 eggs. If you don't want to store more than 10 eggs print only Egg_Holder_Stackable_Lower. I made the files from scratch with Fusion360 after I tried the one by ppnacho which didn't really work for me sadly. (https://www.printables.com/de/model/29711-expandable-eggs-holder/comments/620637) ---------------------------------------------------------------------------------------------------------------- THERE IS A NEW VERSION AVAILABLE HERE. ---------------------------------------------------------------------------------------------------------------- If you want to help me out a bit and see some stuff I made, work in progress, or models before they will be here consider liking and following my Facebook page , thank you very much - it means a lot to me! :) ---------------------------------------------------------------------------------------------------------------- Print with: PLA 3 wall loops and top / bottom shell layers 15% infill no supports are needed Parts: Egg_Holder_Stackable_Lower Needs to be printed once ~50g filament Egg_Holder_Stackable_Upper Can be printed as many times as you like ~60g filament Updates: none so far ---------------------------------------------------------------------------------------------------------------- I'm looking forward to your comments and makes. :)