About this 3D model

this was an image i created from midjourney and then setup in hueforge as a learning process. Printing with a pre-made hueforge profile is a breeze just try and match the colors in the profile description as best you can, or feel free to mix and match if you'd rather not mess with the program itself! While an AMS makes this easier, its entirely unnecessary as these are layer swaps only. With your filaments of choice loaded and calibrated as usual, open the 3mf and slice the model. Add the following swaps at the intervals. Reslice and print. Swap Instructions: Start with Black At layer #10 (0.6mm) swap to Brown At layer #12 (0.68mm) swap to Orange At layer #17 (0.88mm) swap to Yellow At layer #23 (1.12mm) swap to White for the rest.